ATC tower provides airfield overwatch

Staff Sgt. Kyle Margeson, air traffic controller watch supervisor, and Staff Sgt. Jose Rodriguez, air traffic controller apprentice, both of the 305th Operations Support Squadron, scan the runway for birds and debris to maintain situational awareness Jan. 11, 2013, at the air traffic control tower. The OSS provides the safe flow of arrivals and departures 24/7 to Joint Base McGuire-Dix-Lakehurst, N.J. Margeson hails from Carlisle, Pa., and Rodriguez hails from Philadelphia. (U.S. Air Force photo by Russ Meseroll/Released)

JB MDL safety office identifies hazards

Master Sgt. Scott Keister, Joint Base McGuire-Dix-Lakehurst Safety Office non-commissioned officer in charge, performs a walk-through inspection Jan. 9, 2013, at a warehouse on JB MDL, N.J. The office conducts spot inspections for hazard identification and safety issues. Their main goal is for mishap prevention by detecting potential areas and educating the workforce of them. Keister hails from Lawrenceville, Pa. (U.S. Air Force photo by Russ Meseroll/Released)

621st CRW

Staff Sgt. Javier Borges (left), 571st Mobility Support Advisory Squadron loadmaster air advisor, looks on as members of the Colombian air force tighten the side nets for a pallet sent to Barranqilla from Commando Aéreo de Transporte Militar, Bogota, Colombia for Colombian air force’s preparation to participate Red Flag June 25, 2012. Prior to full operational capability, MSAS Airmen have engaged in extensive training, including: an air advisor course, an academic instructor course, and a survival, evasion, resistance and escape course. (U.S. Air Force photo by Tech. Sgt. Lesley Waters/Released)

Rear Adm. Darrah Visits JB MDL

Mechanical engineer Christine Farrell describes the three-dimensional printing and rapid prototyping capabilities of Lakehurst’s Support Equipment Division to Rear Adm. Mark Darrah during his visit Jan. 9, 2013, to Joint Base McGuire-Dix-Lakehurst, N.J. Farrell is holding a 3D printed model of the MH-60R Oil Line Nut Wrench that saves 80 man hours per routine helicopter oil change. The models are used for fit and function testing, as well as early problem detection. Looking on are John Schmelzle and Kathleen Donnelly. (U.S. Navy courtesy photo/Released)

General redesignates Army training division

Brigadier General John H.H. Turner III, Atlantic Division, 75th Training Command (Mission Command), speaks during the 2nd Brigade 75th Training Division (Mission Command) redesignation ceremony Dec. 1, 2012, at Doughboy Gym. The unit was renamed during the ceremony to harmonize the unit's name with the other U.S. Army training commands. (U.S. Air Force photo by 2nd Lt. Alexis McGee/Released)

MFSC offers one-stop service

The new Military and Family Support Center facade shines in the sunlight. The MFSC welcomes service members and families to the ribbon cutting ceremony held from 1:30 to 2:30 p.m. today at 3435 Broidy Road. (U.S. Air Force photo by Kim Wright/Released)